CDVI Galeo - Adding, Changing, or Deleting User Codes; Time Outputs Configuration

  
  
 
2beepsareemittedtoconrmthatthekey-
  padisinstand-byoperatingmode.

 
Group1:Fromaddress00toaddress99,
   relayoutput1
   
  
  2beepsareemittedtoconrmentry
  inprogrammingmode.
  
  
  Iftheuserlocationisfree1beep
  isemitted,enterthe4or5-digit
  Usercode.
  
  
  4beepsareemittedtoindicatethat
  userlocationisalreadyprogrammed.
  Enteranew4or5-digitcode.
  Abeepisemittedtoconrmthenew
  usercode.
  
  
  4beepsareemitted.
  Pressin5-digitlengthcode
  orin4-digitlengthcode.
  Abeepisemittedtoconrmthenew
  usercode.
 
IfthePincodeisalreadyprogrammed
  orisidenticaltothemastercode,
  then4beepsareemitted.
  Presstoexitfromtheprogramming
  mode.2beepsareemittedtoconrm
  thatthekeypadisinstand-by
  operatingmode.

 
 
 
   
  (defaultvaluemastercode).
  2beepsareemittedtoconrm 
  entryinprogrammingmode.
  
  
 
Enterthetimein10th 
  ofsecond–10for10secondsupto99
  for99secondsthebacklightingdims
  10secondsafterthelastkeypress
  orswitchesoffafterenteringavalidcode.
  Pressforpermanentilluminationkeys.
  Onebeepisemittedtovalidatethetime.
  
  
  1beepisemitted.Foralatchedoutput
  enterthetimeinseconds–01for1
  secondupto99for99seconds.
  Pressforatoggledoutput.
  Onebeepisemittedtovalidatethetime.
  
  
  2beepsareemittedtoconrmthatthekey-
  padisinstand-byoperatingmode.





  
  
  Wait1secondandthenremove 
  thejumper.Onebeepisemitted.
  Themastercodeisrestored
  toitsdefaultvaluein5-digit
  codeandin4-digitcode.

 
 
 
 

  
  Therelayisactivatedandabeep
  isemitted.
  
  
  Abeepisemittedtoauthorise
  themodication.
  
  2beepsareemittedtoconrm
  thenewcode.
 4. Checkthenewusercodetobesure
  ofthemodication.

IlluminatedWeatherproofKeypadwithremoteelectronics
 
11
cdvi.se
cdvigroup.com