Need help?Do you have a question about the cec BD-5200 and is the answer not in the manual?
Lists tools needed for taking the unit apart.
Instructions for removing the unit's outer casing.
Procedure for detaching the motor from the chassis.
Guide to detach the main internal sub-chassis assembly.
Lists tools needed for calibration and tuning.
Procedure to ensure the turntable is balanced and at the correct height.
How to set the needle's vertical position relative to the record.
Adjusting stylus height manually during playback.
Setting the correct placement of the turntable spindle.
Fine-tuning the automatic arm return function.
Setting the cueing lever to operate correctly with the tone arm.
Calibrating the platter rotation speed.
Instructions for switching between different voltage inputs.
Solutions for when the tone arm doesn't lift at the end of playback.
Diagnosing delays in the auto return function.
Fixing premature tone arm return during playback.
Troubleshooting steps for a stationary platter.
Resolving issues where the platter continues spinning.
Diagnosing problems with speed calibration.
Identifying and fixing unwanted noise during operation.
Steps to resolve audio output issues.
Troubleshooting when the stylus does not engage the record.
Resolving issues with the speed indicator light.
Procedure for replacing the tonearm assembly.
How to replace the central spindle.
Steps for installing a new motor unit.
Replacing the cueing mechanism.
Procedure for replacing the lifter shaft.
Diagrams showing electrical schematics for different models.
General| Drive method | Belt Drive |
|---|---|
| Motor | DC motor |
| Speeds | 33 1/3, 45 rpm |
| Platter | 300mm, aluminum die-cast |
| Tonearm | Static balanced straight arm |
| Cartridge weight range | 4 to 9g |
To Next Page
