cecotec bolero SQUAD 3000 - Operation; Connection to the mains

BOLERO SQUAD I 3000
61
ENGLISH
- To avoid any damage, the bonding layer and the adhesive must be heat resistant.
Connection to the mains
Fig. 9
The induction hob must be connected to the mains by a suitably qualied person.
Before connecting the hob to the mains, check that:
1 Your home wiring system is suitable for the power consumption of the cooking hob.
2 The mains voltage matches the voltage stated on the rating label of the appliance.
3 The power cable sections can withstand the load specied on the product rating label.
- To connect the induction hob to the mains, do not use adapters, reducers or branching
devices, as they may cause overheating or re.
- The power cable should not be in contact with any hot parts and must be positioned so
that its temperature does not exceed 75°C at any time.
Warning
Check with an electrician whether your home wiring system is suitable without modifying it.
Any modications should only be carried out by a qualied electrician. Fig. 9
- If the cable is damaged, it must be replaced by the manufacturer, the supplier or similarly
qualied personnel in order to avoid a hazard.
- If the appliance is connected directly to the mains, a single-pole residual current circuit
breaker with a minimum contact separation of 3 mm must be installed.
- The person in charge of the installation must ensure that a correct electrical connection
has been made and that it complies with safety regulations.
- Do not bend or press the cable.
- Check the cable for damage regularly.
Note:
The bottom surface and the power cable of the hob should not be accessible after installation.
4. OPERATION
The induction hob works by electromagnetic vibrations that generate heat directly in the
cookware, rather than indirectly by heating the surface of the glass. Glass heats only because
the frying pan eventually heats it up.
Fig. 10
1 Cookware
2 Magnetic circuit
3 Glass ceramic hob
02502_Placa Bolero Squad I 3000 _IM_YV_01220125.indd 6102502_Placa Bolero Squad I 3000 _IM_YV_01220125.indd 61 10/2/22 17:3610/2/22 17:36