cecotec bolero SQUAD 3000 - Technical Specifications

BOLERO SQUAD I 3000
73
ENGLISH
Heating stops suddenly
during operation and the
display shows a ashing
‘u’.
The cookware is not
suitable.
Use a suitable
cookware.
The cookware
detection
circuit is
damaged,
replace the
power supply
board.
The cookware
diameter is too
small.
The hob has
overheated.
The unit has
overheated. Wait for
the hob temperature
to return to normal.
Press the On/o
button to restart the
product.
When trying to heat
areas of the same size,
like areas 1 and 2, the
display shows ‘u’.
The power supply
board and the board
connected to the
display malfunction.
Check the
connections.
The display board on
the communication
unit is damaged.
Substitute the
display board.
The main board is
damaged.
Substitute the power
supply board.
The fan motor produces
unusual noises.
The motor fan is
damaged.
Substitute the fan.
Note
- These instructions are intended for qualied technicians, do not attempt to carry them
out if you do not have the necessary training and knowledge, as any damage caused by an
incorrect repair will void the warranty.
- Do not try to disassemble the unit on your own to avoid hazards and damages to the
induction hob.
7. TECHNICAL SPECIFICATIONS
Product reference: 02502
Product: Bolero Squad I 3000 hob
Cooking areas: 3 areas
Supply voltage: 220-240 V~ 50/ 60 Hz
02502_Placa Bolero Squad I 3000 _IM_YV_01220125.indd 7302502_Placa Bolero Squad I 3000 _IM_YV_01220125.indd 73 10/2/22 17:3610/2/22 17:36