cecotec CHOPBEAT 1500 - Parts and Components; Before Use; Product Assembly

CHOPBEAT 1500 TITANBLACK GLASS/STEEL/GLASS&STEEL
31
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. First-level button
2. Second-level button
3. Power cord
4. Motor
5. Lid
6. Seal ring
7. Side blade
8. Main blade
9. Spindle
10. Gasket
11. Shaft-sealer ring
12. Bowl
13. Gasket
14. Screw
15. Non-stick plate
16. Spatula
2. BEFORE USE
- Take the product out of the box.
- Remove all packaging materials. Keep the original box.
- Make sure all the components are included and in good conditions, otherwise, contact
immediately the ofcial Technical Support Service of Cecotec.
3. PRODUCT ASSEMBLY
1. Before using it, clean any part that can come into contact with the food.
2. Take out the mini chopper and all the other accessories and clean them with water. Then,
use a wet cloth to clean the motor unit.
3. Place the anti-slip mat on a at surface and then assemble the chopper’s bowl on it. Fig. 2
4. Assemble the shaft to the main unit and add the food inside. Fig. 3
5. Cover the main unit with the lid. Fig. 4
6. Assemble the motor inside the chopper. The blades’ shaft should be aligned with the hole
in the middle of the main unit. Fig. 5