cecotec CHOPBEAT 1500 - Cleaning and Maintenance; Troubleshooting

CHOPBEAT 1500 TITANBLACK GLASS/STEEL/GLASS&STEEL
33
ENGLISH
Ingredients Recommended max.
amount
Ingredients Recommended max.
amount
Vegetables 300g Bread 2 pieces
Garlic 300g Onion
(quartered)
300g
Pepper 200g Pork (20mm
pieces)
300g
Peanut 200g Beef (20mm
pieces)
300g
5. CLEANING AND MAINTENANCE
- Disconnect the appliance from the power supply and allow it to cool down before cleaning.
- Use a soft, damp cloth to clean the product’s surface. Do not immerse the motor in water.
- Do not immerse the appliance in water or other liquid.
- Do not use abrasive scouring pads, powders or cleaners.
- Wash the removable parts with soap and warm water. Rinse well and let dry.
- The motor is not dishwasher-safe, but the parts which do not have electrical components
are.
- The cutting edges of the blades are very sharp, clean them carefully.
- Dry the device and components before assembling them back.
6. TROUBLESHOOTING
Problem Cause Solution
The device does not work. The lid is not in place. Check the lid and cover it
correctly.
Bad smell comes from the
motor.
The motor is new. It is
completely normal.
If the device has been used
several times and it still
emits that bad smell, contact
Cecotec technical support
service.
The device stops operating
suddenly.
The voltage is too low.
The overheating-protection
system started working.
Check the voltage level.
Let the device rest for 20-30
minutes.