cecotec COMINO 1000 - Parts and Components; Box Contents; Before Use; Initial Cleaning

COMINO 1000
29
ENGLISH
1. PARTS AND COMPONENTS
Fig. 1
1. Motor base
2. Food pusher
3. Processing vessel lid
4. Toolholder A (processing axis-A)
5. Toolholder B (processing axis-B)
6. Processing vessel
7. Cutting blades unit
8. Plastic kneading blade
9. Blade holder disc
10. Fine grinding blade
11. Thin cutting blade
12. French fries blade
13. Squeezing cone
14. Squeezing lter
15. Emulsifying disc
NOTE:
The graphics in this manual are schematic representations and may not exactly match the
device.
2. BEFORE USE
- This device is packaged in a way as to protect it during transport. Take the device out
of its box and remove all packaging materials. You can keep the original box and other
packaging elements in a safe place. This will help you prevent damage to the device when
transporting it in the future. In case the original packaging is disposed of, make sure all
packaging materials are recycled accordingly.
- Make sure all parts and components are included and in good conditions. If there is any
piece missing or in bad conditions, contact the ocial Cecotec Technical Support Service
immediately.
- Clean components that will come into contact with food with water and a non-abrasive
detergent before rst use.
Box content
- Food processor
- Kneading blade
- French fries blade