cecotec COMINO 1000 - Technical Specifications

COMINO 1000
32
ENGLISH
Food cannot be
processed
Ingredients are
too greasy.
Cut the food into several pieces, not too small, until
it ts right through the feed hole in the cover of the
processing bowl.
Ingredients are
too greasy.
Due to the strength of the product, this does not
usually occur, but some foods may be excessively
hard. To soften them, place them for a few seconds in
the microwave.
The shaft does
not rotate
The accessory
you are using
has not tted
properly.
Fit the tting properly on the shaft so that it rotates
on the shaft.
The motor is
blocked.
The motor may not work, even if the appliance
is switched on. In that case, contact the ocial
Technical Support Service of Cecotec.
White smoke
comes out of
the appliance.
The appliance is
faulty
Contact the ocial Cecotec Technical Support Service.
The appliance
is too hot
The motor has
been blocked for
too long
It is not usual, but it may be that the food is not being
ground properly and the motor has been blocked for
too long, causing it to overheat. Allow to cool for at
least 10 minutes before reuse.
7. TECHNICAL SPECIFICATIONS
Product reference: 04351
Product: Comino 1000
Power: 500 W
Engine blocking power: 1000 W
Voltage: 220-240 V
Frequency: 50/60 Hz
Technical specications may change without prior notication to improve product quality.
Made in China | Designed in Spain