cecotec CONGA 1790 VITAL - Safety Instructions

CONGA 1790 | 23
ENGLESK
Safety instructions
Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
This product must be used in accordance with the directions
in this instruction manual. Cecotec cannot be held liable or re-
sponsible for any damages or injuries caused by improper use.
Make sure that the mains voltage matches the voltage stated
on the rating label of the appliance and that the wall outlet is
grounded.
This product can only be disassembled by qualied personnel.
Do not touch wires, power supplies or power adapters with
wet hands.
Keep the robot away from clothing, curtains and any other sim-
ilar materials.
Do not expose the robot to direct sun, open re or wet environ-
ments.
Do not sit or place heavy or sharp objects on top of the appli-
ance.
This product is designed for indoor use only, do not use out-
doors.
Before operating the robot, remove all objects and wires that
could aect its operating.
Always place the device on a at and stable surface. Avoid
placing it in unstable places where there is risk of falling, such
as tables or chairs.
Turn o the power switch, located on the bottom part of the
robot, when it is not going to be used for a long time.
Before operating it, make sure all the robot’s and charging
base’s connections are in good conditions.
Avoid operating the product under extremely high or low tem-
peratures.
Remove the battery from the product’s inside before scrapping
the robot.
Disconnect the appliance from the power supply before re-