cecotec CONGA 1790 VITAL - Technical Specifications

34 | CONGA 1790
ENGELSK
The robot does not
charge
Check if the indicator on the charging base are light-
ed up. If not, contact the Technical Support Service of
Cecotec.
Clean the charging terminals with a dry cloth.
Check if the robot beeps when it gets to the charging
base. If not, contact the Technical Support Service of
Cecotec.
The robot does not return
to the charging base
Remove objects within 3 ft/1 m to the left and right
side and within 6 ft/2 m of the front of the charging
base.
The robot will return quicker to the charging base
when it is close to it. If the robot is far away from it, it
will take longer to detect it.
Clean the charging terminals.
The main brush does not
rotate
Clean the main brush.
Check if the main brush is properly installed.
The robot movements
and routes are usual.
Clean the sensors carefully with a dry cloth.
Restart the robot by turning the power switch
o and on.
6. TECHNICAL SPECIFICATIONS
Product: Conga 1790 Vital
Product reference: 05471
Output voltage: 19 V DC
Output current: 0.6 A
Power: 40 W
Battery: 14.4 V DC Li-Ion 2600 mAh
100-240 V AC ~, 50/60 Hz
Made in China | Designed in Spain