cecotec Conga 1990 Ultimate - Troubleshooting; Technical Specifications; Disposal of Old Electrical Appliances; Technical Support and Warranty

4746
ENGLISH ENGLISH
7. TECHNICAL SPECIFICATIONS
Product: Conga 1990 Ultimate
Product reference: 05693
Voltage: 100-240 V ~, 50/60 Hz
Battery: 14.4 V, 2600 mAh
Frequency bands: 2.4 GHz
Maximum Transmission Power: 17.5 dBm
Technical specications may change without prior notication to improve product quality.
Manufactured in China | Designed in Spain
8. DISPOSAL OF OLD ELECTRICAL APPLIANCES
This symbol indicates that, according to the applicable regulations, the
product and/or battery must be disposed of separately from household
waste. When this product reaches the end of its shelf life, you should
dispose of the batteries/accumulators and take them to a collection point
designated by the local authorities.
Consumers must contact their local authorities or retailer for detailed
information concerning the correct disposal of old electrical appliances
and/or their batteries.
Compliance with the above guidelines will help protect the environment.
9. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at
the time of delivery of the product under the terms, conditions and deadlines established by
the applicable regulations.
It is recommended that repairs be carried out by qualied personnel.
If at any moment you detect any problem with your product or have any doubt, do not
hesitate to contact Cecotec ocial Technical Support Service at +34 963 210 728.
10. COPYRIGHT
The intellectual property rights over the texts in this manual belong to CECOTEC
INNOVACIONES, S.L. All rights reserved. The contents of this publication may not, in whole or
in part, be reproduced, stored in a retrieval system, transmitted or distributed by any means
(electronic, mechanical, photocopying, recording or similar) without the prior authorization of
CECOTEC INNOVACIONES, S.L.
6. TROUBLESHOOTING
Robot signal Cause Solution
Steady red
light
1 beep Omnidirectional wheel
error.
Clean the omnidirectional wheel
and press the Start/Pause
button to restart the robot
vacuum cleaner.
2 beeps Side brushes error Clean the side brushes and
press the Start/Pause button
to restart the robot vacuum
cleaner.
3 beeps
Suction motor error
Remove the tank and empty it.
Remove the robot lter and
shake o the dirt.
4 beeps Main brush error Remote and clean the main
brush and press the Start/
Pause button to restart the robot
vacuum cleaner.
Flashing red
light
1 beep Mixed tank error Introduce the dust tank and
press the Start/Pause button
to restart the robot vacuum
cleaner.
2 beeps Bumper error Check if the bumper is blocked
and press on both sides and
center to unblock it.
3 beeps Free-fall sensor error Check if the robot is placed on an
uneven surface, if its wheels are
o the ground or if it is stuck in a
dark place and move it to a new
location. Otherwise, clean the
free-fall sensor.
4 beeps The robot cannot return
to its charging base or
starting position.
Make sure there are no obstacles
in front of the charging base.
Clean the charging terminals on
both the charging base and the
robot with a clean, soft and dry
cloth.