cecotec Conga 2290 Ultra - Robot Operation and Cleaning Modes; Starting and Pausing Cleaning; Cleaning Mode Selection

6160
ENGLISH ENGLISH
Turn o
Hold down the power button to turn the robot o. Fig. 26
Warning
The robot vacuum cleaner has a power switch located on its main body. If the robot is not going
to be used for long periods of time, it is suggested to switch it o. If the robot is switched o, it
will restore factory default settings as a safety measure. To use the time setting function, the
switch must be in On position. Otherwise, you will have to reset it using the remote control or
the App.
Cleaning modes
This robot includes dierent modes and dierent functions that can be activated from the
remote control or the App.
Automatic mode
- Press the power button for the robot to start Auto cleaning mode.
- The robot will clean the whole surface, edges, around objects like tables, chairs etc. Once it
starts running out of battery, it will return to the charging base. Fig. 27
Intense scrubbing mode
- Attach the mop cloth to the water tank and ll the tank with water.
- Take the dust tank out.
- Install the water tank in the robot and turn it on. Fig. 28
- Use the remote control to select the desired scrubbing power level: High, Medium or Low.
- Once the scrubbing mode is selected from the remote control or the App, the device will
perform the function “All in One” to vacuum, mop and scrub at the same time thanks to its
Wet & Dry tank.
Note
- If you want to sweep the oor, skip the water-lling step.
- To ensure perfect scrubbing from the start, it is suggested to dampen the mop cloth evenly
with water before use.
Spiral mode
- The robot will carry out an intense cleaning of a specic area when this mode is activated.
The robot will start cleaning at a specic point and will move outwards performing spiral
movements (1 metre). Then, it will return to the starting point in spiral movements again.
- Before operating the robot with the Spiral cleaning mode, place it on the spot to be cleaned.
- Press the Spiral cleaning button on the remote control or on the App. Fig. 29
Edge mode
- When this mode is selected, the robot will clean along walls and around furniture (e.g.
table or chair legs).
- Press the edge cleaning button on the remote control or on the App. Fig. 30
Room mode
- When this mode is selected, the robot will clean in Automatic mood and then it will get
back to the starting point.
- Press the room cleaning button on the remote control or on the App. Fig. 31
- To ensure an ecient cleaning of the room, close the door or use the magnetic strip.
Suction power level function
Press the power level button on the remote control or on the App in order to control the robot’s
vacuum power during the cleaning process. There are 3 suction power levels: Turbo, Normal
and Eco. You can turn the power level function o if you want to use the mixed tank only to
scrub. Fig. 32
Scrubbing intensity function
Press the scrubbing level button on the remote control or on the App to set the water level
during the scrubbing process. There are 3 water levels: High, Medium or Low. You can turn the
power level function o if you want to use the mixed tank only to sweep.
Random mode
- The robot will clean randomly and will smartly return to the charging base when it runs
out of battery. The robot will not create any map under this mode.
- This mode can be selected from the App.
Manual mode
The robot will move manually by using the arrows in the remote control or on the App.
Magnetic strip
Use the magnetic strip included to delimit the cleaning area so the robot is not able to access
to certain areas.
Cleaning scheduling
This robot includes schedule settings in order for you to customize the cleaning cycles. The
scheduling can only be made through the remote control or through the App.