6766
ENGLISH ENGLISH
02 2 Bumper error Check the bumper
and remove any
object that may be
blocking it.
03 3 Free-fall sensor error Check if the bumper
is dirty and clean the
sensor.
02 4 Low battery or
charging error
The robot has run
out of battery and
you need to manually
place it on the
charging base.
Beeps while the indicator light is steady red:
Beeps Error Solution
01 1 Driving wheel error Check if the driving
wheel is blocked.
02 2 Robot's side brushes
error
Check if the side
brushes are blocked
and clean them.
03 3 Fan error Clean the dust or
objects that may be
blocking the air inlet
channel.
02 4 Main brush error Check if the main
brush is tangled or
blocked and clean it.
Other possible scenarios
Problem Solution
The robot does not turn on Make sure that the switch is set to the On
position.
Make sure the battery is fully charged.
Change the remote control batteries (2 AAA).
Make sure the remote control is within the
robot range (16 ft/5 m).
If the problem continues, turn the switch o
and restart it.
The remote control does not work. Change the remote control batteries.
Make sure the robot is on and the battery is
fully charged.
The device suddenly stops working. Check if the robot is trapped or stuck with any
obstacle.
Check the battery level.
If the problem continues, turn the switch o,
wait for 2 seconds and restart it.
The programming function does not work Make sure the power switch in the lower part
of the robot is on.
Make sure the time (AM/PM) and time
settings are correctly set.
Check if the robot’s battery is too low to turn
on.
Suction power level is very low Check if there are obstructions blocking the
air inlet.
Empty the dust tank.
Clean the lters with a vacuum cleaner or a
cleaning brush.
Check if the lters are wet.
Dry the lters in a natural way before using
them.
To Next Page
Loading...
