CONGA 4690 | 29
ENGLESK
2. BEFORE USE
Take the product out of the box and remove all packaging materials.
Make sure all parts and components are included and in good conditions. If
any sign of visible
damage is observed, contact immediately with the ocial Technical Sup-
port Service of Cecotec
3. INSTALLATION
Robot and charging base installation
Connect the charging base to a power supply and store the remaining cable.
It is important to
store the remaining cable at the bottom of the charging base to avoid it
from being dragged
and disconnected.
Place the charging base against the wall, leaving the safety distance indi-
cated in the below
picture.
Note: Ensure a space of at least 1 m on both the left and right side of the
charging base, and a
space of at least 2 m in front of it.
Warning: Do not expose the charging base to direct sun light.
Long press the power button for 3 seconds; when the light indicator turns
on, place the robot
on the charging base.
1. Steady blue light: ON/operating
2. Oscillating orange light: Charging
3. Red light blinks: Error
Notes:
Take the robot to the charging base if the battery is low. The robot might not
turn on if the battery is very low.
The robot will automatically turn on when placed on the charging base.
The robot cannot be turned o during charging.
Wet & dry and dust tank installation
Recommendation: It is not suggested to use the scrubbing function for the
rst-time use.
Open the tank’s blue silicone lid, ll the tank with water carefully so water
does not come out and close it again. Make sure the silicone clip is properly
closed to avoid water from pilling.
Install the tank in the robot following the indicated direction. Make sure the
To Next Page
Loading...
