cecotec Conga 4690 - Sensor and Filter Cleaning; Battery Replacement and Charging

CONGA 4690 | 39
ENGLESK
High-eciency lter
Remove the high-eciency lter and shake it to remove all the dust.
Recommendations:
Replace the high eciency lter every 3 months depending on the frequen-
cy and type of use.
Clean the lter periodically with a brush to avoid blockage.
The lter can be washed with lukewarm soapy water. Dry it thoroughly.
Side brush
Remove and clean the side brushes regularly.
Recommendation: In order to ensure a perfect cleaning, it is suggested to
replace the side brushes every 3 months, depending on the frequency and
type of use.
Free-fall sensors
Clean the free-fall sensors with a soft cloth regularly.
Warning: Always transport the product turned o and in its original pack-
age.
7. BATTERY REPLACEMENT AND CHARGING
Do not use any other battery, power adapter or charging base than the one
ocially provided by Cecotec. Do not use non-rechargeable batteries.
Do not remove, dismantle or attempt to repair the battery or the charging
base.
Do not place the charging base near heat sources.
Do not use a wet cloth to wipe any of the parts of this product.
If the robot is not going to be used for a long time, remove the battery from
the product and store it in a dry and safe place. It is suggested to charge the
battery every month in order to avoid damage to the battery.
Do not dispose of waste batteries at will. It is suggested to hand them over
to professional organizations for correct treatment.