cecotec Conga 4690 - Cleaning and Maintenance; Brush Care; Tank and Filter Maintenance

38 | CONGA 4690
ENGELSK
6. CLEANING AND MAINTENANCE
Main brush
Turn the robot around and press the main brush’s release button to take the
cover out.
Take the main brush out and clean the compartment.
Clean the main brush with the provided tools and use water and soap if
necessary. Place the main brush in its position and fasten the cover’s clip.
Recommendation: Replace the main brush every 6-12 months to ensure ef-
cient operating (depending on the frequency and type of use).
1. Main brush cover
2. Tab
3. Main brush
4. Compartment
Silicone brush
To clean the silicone brush, follow the instructions on the previous section
to remove it from the robot and wash it with water and soap. Dry it thor-
oughly before assembling it back in order to ensure ecient operation.
Jalisco brush
To clean the Jalisco brush, follow the previous section’s steps to take it out
and clean it with water. Dry it thoroughly before assembling it back in order
to ensure ecient operation.
Dust tank
Take the dust tank out.
Open the dust tank cover and empty it.
Use the cleaning brush to clean the inside of the dust tank.
Install the dust tank back in the robot.
Wet&Dry tank
Take the Wet & dry tank out.
Detach the dust compartment from the rest of the tank.
Open dust compartment and empty it.
Use the cleaning brush to clean the dust compartment.
Assemble the dust compartment in the Wet & dry tank.
Install the Wet & dry tank back in the robot.
If the Scrubbing mode has been used, empty the water tank and then ll it
with clean water to rinse it. Empty it again before installing it back in the
robot.