cecotec Conga 4690 - Page 32

32 | CONGA 4690
ENGELSK
7. Edge mode
Remote control binding
If the robot does not respond to the remote control, follow the below steps:
Press the edge mode button on the remote control for 5 seconds for the
remote control to enter pairing mode. The screen will display 8888.
The remote receiver will be activated in 5 seconds and will enter pairing
mode. The remote control’s signal is received, and the remote control re-
turns to normal status. The display will show pairing is completed.
If the pairing process is unsuccessful, the remote control will display 8888
and will exit the pairing mode after 30 seconds.
The following modes and operations can be activated from the remote con-
trol.
Modes
The rst time the robot is operated, it will map and save the whole house’s
map by means of its laser before starting the cleaning cycle. Use the robot
in Auto mode and Eco power level, this way you will ensure the robot mem-
orizes the full map.
Note: Make sure the light indicator is lighted in blue before starting clean-
ing, indicating it is activated. If not, press any button on the remote control
to wake it up.
Auto mode
Press the power button on the robot for it to start cleaning automatically,
rst a cleaning cycle in Edge mode and then another cycle in and organized
zigzag motion, recognizing which areas it has cleaned and which ones it has
not. The robot will automatically plan the cleaning route as it is cleaning.
If during this mode the robot is controlled manually, the robot will calcu-
late the route again and could go through previously cleaned areas. In order
to ensure ecient cleaning, do not operate it manually during auto mode
cleaning.
Thanks to its Total Surface 2.0 technology, if the battery is low during the
cleaning cycle, the robot will smartly return to the charging base automat-
ically and, once it is fully charged, it will resume the cleaning process from
the same point, oering a high-eciency cleaning. During cleaning, the ro-
bot will stop briey to evaluate the area and calculate the cleaning route
(this stop will vary depending on the house conditions).
Note: The robot cleans in an organized way and per 4x4 m squared areas,
therefore it might leave the room where it is cleaning to nish o the delim-
ited area. Do not worry, the robot will clean all the accessible surface.