cecotec Conga 4690 - Scheduling and Time Settings

34 | CONGA 4690
ENGELSK
After 12 hours of no operation, the robot will turn automatically o.
The robot will not enter standby mode during charging.
Suction power level
Press the power levels button on the remote control to select the desired
power level. Choose between Eco (low power), Medium (medium power)
and Turbo (high power).
Schedule
Warning: The robot cannot be scheduled from more than one device at a
time. Make sure to schedule it either from the mobile phone App or from the
remote control.
The robot is provided with a schedule function in order to provide a max-
imum-eciency cleaning. The time settings and the cleaning schedul-
ing must be carried out from the remote control. Once the robot has been
scheduled, it will automatically carry out the cleaning cycles every sched-
uled day.
Note: Make sure the robot is activated and that the light indicator is lighted
before scheduling any cleaning or setting time.
Current time
Hold down the time button for 3 seconds. The rst 2 digits, indicating the
hour, will start blinking.
Use the up and down direction buttons to set the current time. Then, use
the left and right buttons to switch from hours to minutes and repeat the
before step.
Press the time button to save the settings.
Scheduling cleaning tasks
Long press the schedule button for 3 seconds. The rst 2 digits, indicating
the hour, will start blinking.
Use the up and down direction buttons to set the schedule time. Then, use
the left and right buttons to switch from hours to minutes and repeat the
before step.
Press the schedule button again to save the settings.
To cancel the scheduled cleaning, follow the below steps:
Set the clock on the remote control at 00:00 a.m. and save it.
Switch the robot o for 1 minute and switch it on again.
Note: The robot will beep to indicate all settings have been saved.