cecotec Conga 5490 - Remote Control Operation and Binding

CONGA 5490 | 33
ENGLESK
5.2. Remote control
Fig.16.
Schedule
Power levels (Turbo/Normal/Eco)
Back home
Clock
Manual control
On/Pause
Edge mode
Remote control binding
If the robot does not respond to the remote control, follow the below steps:
Press the Edge mode button on the remote control for 5 seconds for the
remote control to enter pairing mode. The screen will display 8888.
The remote receiver will be activated in 5 seconds and will enter pairing
mode. The remote control’s signal is received and the remote control re-
turns to normal status. The display will show pairing is completed.
If the pairing process is unsuccessful, the remote control will display 8888
and will exit the pairing mode after 30 seconds.
The following modes and operations can be activated from the remote con-
trol.
Modes
The rst time the robot is operated, it will map and save the whole house’s
map by means of its laser before starting the cleaning cycle. Use the robot
in Auto mode and Eco power level, this way you will ensure the robot mem-
orizes the full map.
Note: Make sure the light indicator is lighted in blue before starting clean-
ing, indicating it is activated. If not, press any button on the remote control
to wake it up.
Auto mode
Fig.17.
Press the power button on the remote control for it to start cleaning auto-
matically, rst a cleaning cycle in Edge mode and then another cycle in and
organized zigzag motion, recognizing which areas it has cleaned and which
ones it has not. The robot will automatically plan the cleaning route as it is
cleaning. If during this mode the robot is controlled manually, the robot will
calculate the route again and could go through previously cleaned areas. In
order to ensure ecient cleaning, do not operate it manually during auto
mode cleaning.