34 | CONGA 5490
ENGELSK
Thanks to its Total Surface 2.0 technology, if the battery is low during the
cleaning cycle, the robot will smartly return to the charging base automat-
ically and, once it is fully charged, it will resume the cleaning process from
the same point, oering a high-eciency cleaning. During cleaning, the ro-
bot will stop briey to evaluate the area and calculate the cleaning route
(this stop will vary depending on the house conditions).
Note: The robot cleans in an organized way and per 4x4 m squared areas,
therefore it might leave the room where it is cleaning to nish o the delim-
ited area. Do not worry, the robot will clean all the accessible surface.
Edge mode
Fig.18.
Press the Edge mode button on the remote control for the robot to start
cleaning under this mode. It will automatically start cleaning along all the
surface’s perimeters and then will return to the charging base direct and
automatically. If the robot has not started cleaning from the charging base,
it will return to the starting point.
Note: Press the power levels button to switch between the 3 modes: Turbo/
Normal/Eco.
Back home mode
Fig.19.
Press the Back-home button on the remote control in order to send the ro-
bot to the charging base. This function can be activated during any other
cleaning cycle and the robot will automatically return to the charging base
and stop the cleaning process. The robot will take the shortest route back to
the charging base thanks to its map memorizing and the smart back home
function.
When a cleaning cycle has been completed or the robot’s battery is low,
thanks to its Total Surface 2.0 technology, the robot will also return to the
charging base to avoid running out of battery. Once the robot has recharged,
it will resume cleaning from the point it has stopped.
Warnings:
Remove the Wet & dry tank from the robot before charging it.
Make sure there are no obstacles in the room being cleaned to ensure the
robot can get to the charging base without problems.
To Next Page
Loading...
