cecotec CONGA 6090 ULTA - Operation; Robot Buttons and Modes; Remote Control Operation

4140
ENGLISH ENGLISH
Warnings:
Using cleaning agents in excess might block water outlets.
In order to achieve perfect scrubbing, it is suggested to moisten the mop before using it.
First cleaning
Once the robot and the charging base are completely installed, follow these steps before
scheduling the rst cleaning cycle.
First of all, the robot must be fully charged. It is suggested to allow the robot to charge
overnight. When it is fully charged, it may carry out the rst cleaning cycle and save the rst
map. To do so, activate Auto cleaning mode and Eco power level. It is very important to follow
these indications for the robot to recognize each and every corner in the house and to create
a complete map.
If the house where the robot is going to be used is too big and the robot runs out of battery,
do not worry. The robot returns to the charging base, saves the full map and those that have
not been completed, and once it is charged again, it resumes the cleaning cycle from the
point it has stopped until it maps the whole surface. The robot keeps on mapping constantly,
therefore it adapts independently to each house’s features and continuously improves
previous maps.
4. OPERATION
Once the robot’s light indicator changes from oscillating orange to steady blue, the battery is
fully charged, and the robot is ready to operate.
The robot cannot operate with low battery.
Recommendations: Remove all cables and obstacles from the oor before operating the
robot in order to avoid accidents and damage.
Robot buttons
Fig.15.
Auto mode
Press the power button on the robot for it to start cleaning automatically, rst a cleaning
cycle in Edge mode and then another cycle in and organized zigzag motion, recognizing which
areas it has cleaned and which ones it has not. The robot will automatically plan the cleaning
route as it is cleaning. If during this mode the robot is controlled manually, the robot will
calculate the route again and could go through previously cleaned areas. In order to ensure
ecient cleaning, do not operate it manually during auto mode cleaning.
Thanks to its Total Surface 3.0 technology, if the battery is low during the cleaning cycle, the
robot will smartly return to the charging base automatically and, once it is fully charged, it
will resume the cleaning process from the same point, oering a high-eciency cleaning.
In order to optimise the whole process, the robot will automatically calculate the necessary
charging time according to the surface to be cleaned. During cleaning, the robot will stop
briey to evaluate the area and calculate the cleaning route (this stop will vary depending on
the house conditions).
Note: The robot cleans in an organized way and per 4x4 m squared areas, therefore it might
leave the room where it is cleaning to nish o the delimited area. Do not worry, the robot
will clean all the accessible surface.
Back home mode
Press the Back home button
This mode can be activated during any other cleaning cycle and the robot will stop cleaning
and return to the charging automatically.
The robot will take the shortest route back to the charging base thanks to its map
memorizing and the smart back home function.
When a cleaning cycle has been completed or the robot’s battery is low, thanks to its Total
Surface 3.0 technology, the robot will also return to the charging base to avoid running out of
battery. Once the robot has recharged, it will resume cleaning from the point it has stopped.
Recommendation: Remove the Wet & dry tank during charging.
Remote control
Fig.16.
Schedule
Power levels (Turbo/Normal/Eco)
Back home
Clock
Manual control
On/Pause
Edge mode
Remote control binding
If the robot does not respond to the remote control, follow the below steps:
Press the Edge mode button on the remote control for 5 seconds for the remote control to
enter pairing mode. The screen will display 8888.
The remote receiver will be activated in 5 seconds and will enter pairing mode. The remote
control’s signal is received and the remote control returns to normal status. The display will
show pairing is completed.
If the pairing process is unsuccessful, the remote control will display 8888 and will exit the
pairing mode after 30 seconds.