cecotec Mambo 9090 - Technical Specifications

57
ENGLISH
E2 Temperature
sensor error
The jar is not in its correct
position or connection of the
temperature sensor at the jar
base is damaged.
Re-assemble the jar and make
sure it is xed properly.
E3 The motor is
blocked.
There is too much food inside
the jar.
Remove some food from
inside the jar or cut the food to
smaller pieces and restart the
machine.
E4 The temperature is
too high.
There is no or very little
food in the jar and the set
temperature is too high for
too much time.
Add food in the jar.
E5 The motor’s
temperature is too
high.
The robot has been operating
with too much food for a lot
of time.
Stop operating the machine
and allow it to cool down
before restarting it again.
E6 The change in
speed could not be
done successfully.
Speed change between low
level (1-5) and high level (6-
10) was blocked.
Remove the jar, turn the xing
bracket manually and place
the jar again in place. Restart
the robot.
E7 & E8 Please, contact the Technical
Support Service of Cecotec at
+96 321 07 28.
E12 Scale
measurement
error.
The maximum measurement
value has been exceeded.
Remove weight from the scale
until it reaches a value below
4.999 g.
8. TECHNICAL SPECIFICATIONS
Model: Mambo 9090
Product reference: 04132
1700 W (Motor 700 W Heating power 1000 W) 200-240 V~ 50/60 Hz
Made in China | Designed in Spain