English - 30 -
Software Update
automatically via Internet.
Software update via internet
On the Home Screen enter the Settings>Device Pref-
erences>About
system version. Move the focus to the System update
OK. You will be informed about the
system status and the time at which the device was last
Check
for updateOK if you
Note: Do not unplug the power cord during the reboot process.
If the TV fails to come on after the upgrade, unplug, wait for
two minutes then plug it back in.
Troubleshooting & Tips
TV does not switch on
Wait for one minute then reconnect it.
Press the Standby/On
TV does not respond to the remote control
Check if the remote control is working by means of
to be checked.
and needs to be checked.
This method of checking the remote control is not
No Channels
that the correct network is selected.
Make sure that the correct channel list is selected.
Make sure that you have entered the correct channel
frequency if you have done manual tuning.
No picture / distorted picture
Make sure that the antenna cable is not damaged.
Make sure that the correct device is selected as the
Make sure that the external device or source is
resolution and refresh rate.
No sound / poor sound
Make sure that the sound settings are correctly set.
Make sure that the volume is not muted or set to
the balance settings from Sound menu.
Input sources - can not be selected
is dedicated to the connected device.
from the Inputs menu.
To Next Page
Loading...
