13
* When set up except 0.0C, a zero clearance is not carried out
even if it pushes a Clear key.
If a setup is completed, the PRG/SET key will be pressed again.
7.Setup of Buzzer
After displaying , an ON-OFF-FF setup of a buzzer is
displayed. How to sound a buzzer is set up by ▲ and ▼/▶.
（ ：Sound altogether ：Don't sound except exaggerated
torque. ：Only NG sounds.）
If a setup is completed, the PRG/SET key will be pressed again.
8. End of Setup
It is displayed and is a setting end. Green LED disappears.
(The inside of setting mode has turned on green LED )
* When ending a setup on the way, press the CLEAR key. It is
displayed as and will be in the state where it can measure.
Green LED puts out the light.
* What value or when the numerical value set up now checks, it
presses the MODE key. The item of the numerical value set as a
display board now is displayed.（ 、 、 、 、
、 ）
5.3 How to Use Convenient Function
I introduce the method of the measurement using a convenient function.
5.3.1 Yes-no Decision
A measurement result judges the inside of a fiducially point, or the outside of a fiducially point, and tells you
about at a lamp or a buzzer.
.1. Set up the "maximum value" and the "minimum value" used as a standard. (Reference 5.2)
2. Measurement mode checks in "PP."(Only measurement mode "PP" of a yes-no decision is effective)
3. When measured value is between a minimum and a maximum , a GOOD lamp lights up.
When measured value is not between a minimum and a maximum, NG lamp blinks and a buzzer sounds.
4. If measurement is completed, the CLEAR key will be pressed and an indication will be given zero.
At this time, the lamp and buzzer of a yes-no decision disappear.
A yes-no decision is performed only when measurement mode is "P-P."(10 or more digits)
Detection of the value of a peak-down switches on a Green (GOOD) lamp at the time of P-D mode.
Intermittence sound (slowly)
Intermittence sound (quick)
Below minimum value * While the load under measurement has not reached a minimum value, it judges, when
load is almost lost (less than 20 digits). (It does not judge, when maximum does not reach 20digit(s))
The item under setup is checked.
When setting up for sounding a buzzer
To Next Page
Loading...
