Cedima CF 13.3 B

To Next Page

To Previous Page

Preparation and operation

CF•13.3 B / CF•13.3 B-L

ENGLISH

Put on the blade guard Figure 4.24

Remount and tighten the rear xing screw Figure 4.25

STOP!

Resharpening blunt diamond saw blades!

Diamond saw blades are designed to sharpen themselves

during operation (while cutting). However, if cutting often

into strong steel reinforcements or hard material with low

abrasion, they can become blunt. They can be resharpened by

cutting into abrasive material such as limestone or asphalt!

Do not subject the diamond segments of the saw blade to

hard impacts as this can destroy them!

STOP!

Change defective, wobbly,

untrue diamond saw blade

with missing segments

Figure 4.26

Cedima CF 13.3 B - Page 23