User manual A100RC+ v1.0EN
5.8. Selecting the radio code
In the event that another radio device is in the vicinity, it may interfere with the operation of your
installation (e.g. a neighbour also has a A100RC+ ), the code can be changed. You will also need to
change the code on the A100RC+ and inside the remote control unit. To do this it is necessary to
1. Cut the power to the A100RC+ ,
2.
Press the key and hold it,
3. Turn on the A100RC+ ,
4. Release the key,
5.
Change the current radio code which appears on the screen (r1 / r2 / r3 / r4),
6.
Use the keys and to set it again,
7.
Press the key to confirm.
There are 10 switches inside the remote control unit (under the battery cover)
which are used to set the code. To open the device, use a screwdriver as illus-
trated in the drawing.
The code displayed on the screen (r1 / r2 / r3 / r4) must correspond to the positions of switches
n°5 and 6.
• A "0" corresponds to the "OFF" switch position
• A "1" corresponds to the "ON" switch position
The other switches must always stay in the same position.
Display Code Positions of the switches
r1
0011001010
r2
0011011010
www.c-
cei.fr
11
To Next Page
Loading...
Need help?
General