Celestron SS80 User Manual

Removing the Lens Covers
To protect your SS80, the objective lens, rear cell, and accessories are
fitted with plastic covers. All are tension-fitted and easily removed by
pulling away from the spotting scope. The covers should be removed
as each piece is installed. Once removed, place the covers in the case
to ensure they won't get lost.
Attaching the Standard Accessories
With your SS80 attached to a sturdy mount, as described earlier in this
manual, you are ready to attach the standard accessories. To do this:
1. Remove the plastic covers from the visual adapter of the spotting
scope and from all the accessories.
2. Loosen the thumbscrew on the visual adapter (back of the spotting
scop>e) so that the opening is unobstructed.
3. Slide the chrome end of the 45® Erect Image Diagonal into the
visual adapter.
4. Tighten the thumbscrew on the visual adapter to hold the 45®
Erect Image Diagonal in place.
5. Loosen the thumbscrew on the eyepiece holder of the 45® Erect
Image Diagonal so that the inner diameter is unobstructed.
6 SS80IC90

Celestron SS80 Specifications

General

Brand	Celestron
Model	SS80
Category	Telescope
Language	English