Celestron SS80 User Manual

Changing Eyepieces
You can vary the power of your SS80 Spotting Scope simply by
changing eyepieces (purchased separately). To change eyepieces:
1. Loosen the thumbscrew on the 45° Erect Image Diagonal.
2. Remove the eyepiece currently installed.
3. Insert the new eyepiece into the 45° Erect Image Diagonal.
4. Tighten the thumbscrew to hold the eyepiece in place.
With the new eyepiece in place you will need to focus your SS80
(unless you are using parfocal eyepieces). Once again, turn the
focusing knob until the image is sharp.
The SS80 uses standard 1-1/4" diameter eyepieces. Celestron offers a
wide variety of eyepieces as optior\al accessories. See the Celestron
Accessory Catalog for a list of additional eyepieces. To determine the
magnification of each eyepiece used with your SS80 Spotting Scope,
see the section "Figuring Magnification" at the end of this manual.
The SS80 can be used without the 45° Erect Image Diagonal by insert¬
ing the eyepiece directly into the visual adapter. Keep in mind that all
images viewed in this nunner are inverted (i.e., upside down and
backwards).
8
SS80/C90

Celestron SS80 Specifications

General

Brand	Celestron
Model	SS80
Category	Telescope
Language	English