Celestron StarSense Explorer DX User Manual

Skip to content
Manuals+
User Manuals Simplified.
Home » Celestron » CELESTRON StarSense Explorer DX User Guide
CELESTRON StarSense Explorer DX User Guide
Contents [ hide
1 StarSense Explorer DX
2 Downloading and Activating the
App
3 Moving the Telescope
4 Aligning the Finderscope
5 File Downloads
6 References
7 Related Manuals
StarSense Explorer DX
Quick Setup Guide
ITEM #22460
1. Unpack your telescope and verify that all parts are present. Your Star Sense Explorer DX includes: a telescope
tube, a tripod and mount head, an accessory bag, slow motion controls, an accessory tray, two eyepieces, an
erect image diagonal, a finder scope, a StarSense phone dock, StarSense Explorer app code card, and a hex
key (hidden inside the slot in the front of the mount head).
2. To set up the tripod, spread the legs outward until they are fully extended and push down the center leg brace.
3. Extend the legs of the tripod by loosening the three hand knobs on each leg. Pull each leg section all the way

Celestron StarSense Explorer DX Specifications

General

Aperture	102 mm
Focal Length	660 mm
Focal Ratio	f/6.5
Mount Type	Altazimuth
Optical Design	Refractor
StarSense App Compatibility	Yes
Lowest Useful Magnification	15x
Limiting Stellar Magnitude	12.5
Resolution (Dawes)	1.14 arc seconds
Optical Coatings	Fully Coated
Included Eyepieces	25 mm and 10 mm
Tripod	Adjustable, full-height
Finderscope	StarSense smartphone dock (no traditional finderscope)