EasyManuals Logo

Celestron StarSense EXPLORER LT 114AZ User Manual

Celestron StarSense EXPLORER LT 114AZ
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
ENGLISH | 1
Unpack your telescope and verify that all parts
are present. Your StarSense Explorer LT includes:
a telescope tube with altitude slow motion rod
attached, a lens cap, an accessory bag, a tripod
with alt-azimuth yoke mount and center leg brace
attached, two tube mounting screws, a StarSense
smartphone dock, two eyepieces, a 2x Barlow
lens, an eyepiece accessory tray, a StarPointer
finderscope and StarSense Explorer app code card.
To set up the tripod, spread the legs outward until
they are fully extended and push down the center
leg brace.
ITEM #22452
Extend the center portion of each of the three tripod
legs down about 6 to 12 inches. Use the tightening
screw on each leg to secure the extended leg in
place.
ENGLISH
114AZ
Quick Setup Guide
Check to ensure that all three legs are the same
height once extended to provide a level platform for
the telescope.
Place the eyepiece accessory tray on top of the
tripod’s center leg brace. Thread the tray into the
threaded hole in the center of the leg brace until it
is fully seated.
NOTE:
If necessary, rotate the accessory tray
counterclockwise until the accessory holes
are not covered by the leg brace arms as
shown here.
Loosen the knob on the altitude rod guide on the
side of the yoke mount so the hole is unobstructed.
Slide the altitude rod into the rod guide on the
mount and lower the altitude hubs on the telescope
tube into the cradles on the top of each yoke arm.
Tighten the altitude rod guide screw to hold the
telescope in place.
Insert the two tube mounting screws through the
yoke mount and into the hubs on the telescope tube
to secure it in place.
To install the finderscope, remove the two silver
nuts from the threaded posts on the top of the tube,
near the focuser.
2
4
5
6
7
8
9
10
1
3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Celestron StarSense EXPLORER LT 114AZ and is the answer not in the manual?

Celestron StarSense EXPLORER LT 114AZ Specifications

General IconGeneral
Aperture114 mm
Focal Length1000 mm
Focal Ratiof/8.77
Mount TypeAltazimuth
Optical DesignNewtonian Reflector
Eyepiece 125 mm
Eyepiece 210 mm
FinderscopeStarPointer red dot finderscope
Highest Useful Magnification269x
Lowest Useful Magnification16x
Limiting Stellar Magnitude12.8
Resolution (Rayleigh)1.22 arc seconds
Resolution (Dawes)1.02 arc seconds
StarSense TechnologyYes
Optical CoatingsAluminum
Height60 in (1524 mm)

Related product manuals