ULT 072517
Page 4 | 1-855-235-5271
Ultimate Series
If any items listed on the packing slip do not match your order information,
contact CellarCool Customer Service immediately.
Please leave the CellarCool unit in its original box until you are ready for installation. This will allow you to move the product
safely without damaging it. When you are ready to remove the product from the box, refer to the installation instructions.
TIP: Save your box and all packaging materials. They provide the only safe means of transporting/shipping the unit.
RECEIVING AND INSPECTING THE UNIT
Upon receiving your CellarCool unit:
• Lift only at the designated hand-hold locations on the shipping container, or fully support the unit from underneath.
A shipment may include one or more boxes containing accessories.
• Inspect the packaging for any obvious signs of damage or mishandling before opening the container.
• Note any discrepancies or visual damage on the bill of lading before signing.
• Place the box containing the CellarCool unit on a tabletop to prepare it for testing prior to installation.
• Sit unit upright for 24 hours.
NOTE: CellarCool units are manufactured in the USA and tested prior to shipment.
• Review the packing slip to verify the package’s contents.
• Check the model number to ensure it is correct.
• Check that all factory options ordered are listed.
• Check the box for the following:
3300 / 4400 / 8800
Ultimate cooling unit
• (1) Ultimate Series owner’s manual
• (18) Anti-microbial pan tabs
• (1) Drain line brush
• (1) Bottle probe (50 feet)
Single-piece mounting bracket
Accessory kit:
• (1) 8-foot power cord
• (2) Mounting bracket insulation foam (6 feet)
• (11) 1¾" standard screws
• (7) ½" self-tapping screws (silver)
• (1) ½" barbed "tee" tting
• (1) Drain line tube (½" ID clear plastic tubing, 10 feet)
To Next Page
Loading...