Store capacitance 2000
Enclosure Double molded, waterproof
Shock (Drop Test) 6.5 feet (2 meters)
Diode Test Test current of 0.9mA maximum, open
circuit voltage 2.8V DC typical
Continuity Check Audible signal will sound if the resistance is
less than 35 (approx.), test current
<0.35mA
PEAK Captures peaks >1ms
Temperature Sensor Requires type K thermocouple
Input Impedance >10MΩ VDC & >9MΩ VAC
AC Response True rms
AC True RMS: The term stands for “Root-Mean-Square,”
which represents the method of calculation
of the voltage or current value. Average
responding multimeters are calibrated to
read correctly only on sine waves and they
will read inaccurately on non-sine wave or
distorted signals. True rms meters read
accurately on either type of signal.
ACV Bandwidth 50Hz to 1000Hz
Crest Factor ≤3 at full scale up to 500V, decreasing
linearly to ≤1.5 at 1000V
Display 40,000 count backlit liquid crystal with
bargraph
Overrange indication “OL” is displayed
Auto Power Off 15 minutes (approximately) with disable
feature
Polarity Automatic (no indication for positive); Minus
(-) sign for negative
Measurement Rate 2 times per second, nominal
Low Battery Indication “ ” is displayed if battery voltage drops
below operating voltage
To Next Page
Loading...