FREQ
SORTING
The setting process:
range setting(use / ) reference value setting (use
/ / / ) tolerance setting(use / ) sorting mode
The tolerance range setting selection: +0.25% +0.5% +1%
+2% +5% +10% +20% +80%-20%. The default
tolerance is +1%.
In the sorting mode,the primary display to show PASS or FAIL
status depends on whether the impedance measured exceeds
tolerance range.The current measurement result will be shown
on the secondary display. Press the button to exit this mode.
If the component to be measured is a capacitor, be
sure that the capacitor is fully discharged BEFORE inserting it
into the input sockets or terminals. For large capacitors, it may
take longer periods of time for a full discharge. Inserting a
charged or partially charged capacitor into the meter’s input
sockets or terminals may produce an electric hazard and may
also damage the instrument, making it unusable.
When the button is pressed, the test frequency will be
changed sequentially. There are five different test frequencies
(100Hz/120Hz/1kHz/10kHz/100kHz) can be selected. The test
frequency can affect the accuracy of the results depending on what
frequency is selected and what type and value of a component
is being measured or tested.
For details on selecting the optimal test frequency for
measurement, refer to the " SUPPLEMENTAL INFORMATION "
section.
→→→
→→ →
→→
→→→→→
WARNING:
Test Frequency Select•
SETUP
ENTER
ENTER
ENTER
14
Dual Display LCR Meter Instruction Manual
To Next Page
Loading...
