To Next Page

To Previous Page

5. Once the System Setup dialog window is open, select Auto Run.

“Auto Run” will automatically run the following procedures, stopping

between each procedure to prompt for user input:

• Magnet Temperature Offset

• SHIM Setup

• Cal-lock

• Frequency Optimization

• Pulse Width Optimization

Correct standard to use for each procedure:

SHIM Setup  Oil Standard

Cal-lock  Normalization Standard

Frequency Optimization  Oil Standard

Pulse Width Optimization  Oil Standard

Questions and Answers:

Need help?

Do you have a question about the CEM Smart Trac II and is the answer not in the manual?

CEM Smart Trac II Specifications

General