CEN-TECH 63873 - Assembly Steps; Attach Wheel Assembly and Foot; Attach Handle and Cable Storage Pegs

Page 7<&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 63873
?@<6AQRS6;@ACRED@CEA6E@ET6 @??6DUGQ
@$$,4.%V.**7%@##*5+7>%,89%<&&$
1. Lay Charger down.
2. Attach Wheel Assembly:
a. Align Wheel Assembly between
slots and screw holes.
b. Slide solid ends of Brackets (43) into slots.
c. Secure Brackets with two Screws (24).
3. Attach Foot (23) with two Screws (24).
U(,4`*$
<&&$
?4(*)
?4(*)
@$$,4.%B,897*%,89%T,+7*%?$&(,3*%S*3#
1. Attach Handle (16):
a. Remove two top screws on each side of Charger.
b. Align Handle with mounting holes.
c. Attach Handle with screws.
2. Attach Cable Storage Pegs%(26)%
with two Screws (27).
?4(*)#
?4(*)#
?4(*)
?4(*)
B,897*
T,+7*%
?$&(,3*%
S*3#