Page 10 <&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1 Item 63873
?@<6AQ RS6;@ACRE D@CEA6E@ET6@??6DUGQ RS6;@ACRE
T.,(3"83%U,$$*(>%C8#$,77*9%"8%!*."47*
@%?S@;j%E6@;%U@AA6;Q%D@Q%T@F?6%U@AA6;Q%6dSGR?CRE1%%
AR%;6XFT6%;C?j%R<%@%?S@;j%E6@;%U@AA6;Q%<RGGRV%AB6?6%CE?A;FTACRE?%6d@TAGQ1%
XR%ERA%SGFW%CE%TB@;W6;0?A@;A6;%FEACG%XC;6TA6X%AR%XR%?R1
AR%S;6!6EA%?6;CRF?%CEaF;Q-%
V*,(%@E?CK,//(&e*9%#/7,#.K(*#"#$,8$%#,2*$>%3&337*#%,89%.*,e>K9'$>%('++*(%)&(`%37&e*#%
).*8*e*(%4&88*4$"83I%9"#4&88*4$"83I%&(%)&(`"83%8*,(%+,$$*(>1%%%
U,$$*(>%,4"9%4,8%4,'#*%/*(5,8*8$%+7"898*##1
V@;ECEWi X&%8&$%'#*%?$,($%#*$$"83%$&%
4.,(3*%+,$$*("*#1%%F#*%$&%='5/%#$,($%&87>1
TRGX%U@AA6;C6?- Begin charging at lowest rate,
increase rate as battery reaches normal temperature.
XR%ERA%TB@;W6%@%<;Rk6E%U@AA6;Q1
1. Unplug Charger/Starter.
2. Position AC and DC cables to reduce risk of
damage by hood, door, or moving engine part.
3. Stay clear of fan blades, belts, pulleys, and
other parts that can cause injury to persons.
4. Check polarity of battery posts. POSITIVE
(POS, P, +) battery post usually has larger
diameter than NEGATIVE (NEG, N,–) post.
5. Determine which battery post is grounded
(connected) to the chassis. If negative post
is grounded to chassis, see a. If positive
post is grounded to the chassis, see b.
a. <&(%8*3,$"e*K3(&'89*9%e*."47*%
(as in most vehicles)-
• Connect POSITIVE (RED) clip from
battery Charger/Starter to POSITIVE
(POS, P, +) ungrounded post of battery.
• Connect NEGATIVE (BLACK) clip to
vehicle chassis or engine block away
from battery. X&%8&$%4&88*4$%47"/%$&%
4,(+'(*$&(I%2'*7%7"8*#I%&(%#.**$K5*$,7%
+&9>%/,($#1%T&88*4$%$&%,%.*,e>%3,'3*%
5*$,7%/,($%&2%$.*%2(,5*%&(%*83"8*%+7&4`1
b. <&(%/&#"$"e*K3(&'89*9%e*."47*-
• Connect NEGATIVE (BLACK) clip from battery
Charger/Starter to NEGATIVE (NEG, N, –)
ungrounded post of battery. Connect POSITIVE
(RED) clip to vehicle chassis or engine block
away from battery. X&%8&$%4&88*4$%47"/%
$&%4,(+'(*$&(I%2'*7%7"8*#I%&(%#.**$K5*$,7%
+&9>%/,($#1%T&88*4$%$&%,%.*,e>%3,'3*%
5*$,7%/,($%&2%$.*%2(,5*%&(%*83"8*%+7&4`1
6. Plug Charger/Starter into grounded 120V receptacle.
7. Turn Power Switch on.
8. Press Function Select Button until desired function
lights up. ;*2*(%$&%A,+7*%U%&8%/,3*%P1%%
V@;ECEWi X&%8&$%'#*%J]!%]^^@%?$,($%
2'84$"&8%2&(%4.,(3"831
9. Press Start/Stop button to start function.
10. When finished, turn Power Switch off, unplug
power cord, remove clip from vehicle chassis,
and then remove clip from battery terminal.
11. After use clean, then store the charger
indoors out of children’s reach.
To Next Page
Loading...
Need help?
General
