Page 12 <&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1 Item 63873
?@<6AQ RS6;@ACRE D@CEA6E@ET6@??6DUGQ
683"8*%?$,($"83
@%?S@;j%E6@;%U@AA6;Q%D@Q%T@F?6%U@AA6;Q%6dSGR?CRE1%%
AR%;6XFT6%;C?j%R<%@%?S@;j%E6@;%U@AA6;Q%<RGGRV%AB6?6%CE?A;FTACRE?%6d@TAGQ1%
XR%ERA%SGFW%CE%TB@;W6;0?A@;A6;%FEACG%XC;6TA6X%AR%XR%?R1
AR%S;6!6EA%?6;CRF?%CEaF;Q-%
V*,(%@E?CK,//(&e*9%#/7,#.K(*#"#$,8$%#,2*$>%3&337*#%,89%.*,e>K9'$>%('++*(%)&(`%37&e*#%
).*8*e*(%4&88*4$"83I%9"#4&88*4$"83I%&(%)&(`"83%8*,(%+,$$*(>1%%%
U,$$*(>%,4"9%4,8%4,'#*%/*(5,8*8$%+7"898*##1
?&5*%e*."47*#%)"$.%&8+&,(9%4&5/'$*(#%5,>%+*%9,5,3*9%2(&5%$.*%."3.K4'((*8$%#$,($"83%&'$/'$1%%%
A.&(&'3.7>%(*,9%$.*%e*."47*%#*(e"4*%5,8',7%+*2&(*%'#"83%$."#%/(&4*9'(*1
V@;ECEWi X&%8&$%'#*%?$,($%#*$$"83%$&%
4.,(3*%+,$$*("*#1%%F#*%$&%='5/%#$,($%&87>1
E&$*-%%During extremely cold weather or when battery
is severely exhausted, charge the battery at 10A for
about five minutes before attempting to start engine.
1. Unplug Charger/Starter.
2. Make sure setting of Engine Start charge rate
matches the vehicle battery. The emergency
starter function should optimally supply at
least 50% of required battery CCA rating.
3. Position AC and DC cables to reduce risk of
damage by hood, door, or moving engine part.
4. Stay clear of fan blades, belts, pulleys, and
other parts that can cause injury to persons.
5. Determine which battery post is grounded
(connected) to the chassis. If negative post
is grounded to chassis, see a. If positive
post is grounded to the chassis, see b.
a. <&(%8*3,$"e*K3(&'89*9%e*."47*%
(as in most vehicles)-
• Connect POSITIVE (RED) clip from
battery Charger/Starter to POSITIVE
(POS, P, +) ungrounded post of battery.
• Connect NEGATIVE (BLACK) clip to
vehicle chassis or engine block away
from battery. X&%8&$%4&88*4$%47"/%$&%
4,(+'(*$&(I%2'*7%7"8*#I%&(%#.**$K5*$,7%
+&9>%/,($#1%T&88*4$%$&%,%.*,e>%3,'3*%
5*$,7%/,($%&2%$.*%2(,5*%&(%*83"8*%+7&4`1
b. <&(%/&#"$"e*K3(&'89*9%e*."47*-
• Connect NEGATIVE (BLACK) clip from battery
Charger/Starter to NEGATIVE (NEG, N, –)
ungrounded post of battery. Connect POSITIVE
(RED) clip to vehicle chassis or engine block
away from battery. X&%8&$%4&88*4$%47"/%
$&%4,(+'(*$&(I%2'*7%7"8*#I%&(%#.**$K5*$,7%
+&9>%/,($#1%T&88*4$%$&%,%.*,e>%3,'3*%
5*$,7%/,($%&2%$.*%2(,5*%&(%*83"8*%+7&4`1
6. Plug Charger/Starter into grounded
120V, 20A receptacle.
7. Turn Power Switch on.
8. Press Function Select Button until
J]!%]^^@%?$,($ lights up.
9. Press Start/Stop button to start function.
10. Turn ignition key.%%If engine fails to start,
charge battery at 10A for an additional five
minutes before attempting to start again.
11. After the engine starts, press Start/Stop button
to stop function, then turn Power Switch off.
12. Unplug power cord, remove clip from vehicle
chassis, and then remove clip from battery terminal.
13. After use clean, then store the charger
indoors out of children’s reach.
To Next Page
Loading...
Need help?
General
