Page 11Item 96308
For technical questions, please call 1-888-866-5797.
Replacing the Battery
1. When the Low Battery symbol is shown on the Display Screen, the batteries are
low and must be replaced.
2. Remove the screw on the Battery Compartment, and replace the batteries with (3)
new batteries of the same type (3VDC CR2032). Be sure all three batteries have the
“+” side facing upward. Incorrect battery polarity will prevent proper operation of the
meter. NOTE: You may have to move the clip to access the Battery Compartment.
TROUBLESHOOTING
Problem Possible Causes Probable Solutions
Tool will not start 1. Batteries worn out.
2. Incorrect battery polarity
1. Replace batteries
2. Ensure that all batteries have
“+” facing upward in Battery
Compartment.
Erratic or incorrect
readings
1. Loose or damaged Test Leads.
2. Poor connection or corroded parts.
1. Check condition on Test Leads.
2. Check condition of part and clean if
necessary.
To Next Page
Loading...
Need help?
General
