Center 110 - Specifications; General Information

1
Read First: Safety Information
․ Never use the meter if the meter or test leads look
damaged.
․ Be sure the test leads and switch are in the correct
position for the desired measurement.
․ Never measure resistance or testing acoustic continuity
in a circuit when power is applied.
․ Never connect the probe to a voltage source when the
test leads are plugged into the 10 A input jack .
․ Never connect the probe to a voltage source when the
function are in
u A or mA range.
․ Never apply more than rated voltage between any input
jack and earth ground.
․ Be careful when working with voltages above 60 V dc or
30 V ac rms. Such voltages pose a shock hazard.
․ Keep your fingers behind the finger guards on the test
probes when making measurements.
․ To avoid false readings, replace the battery immediately,
When symbol appears.
Symbols:
ReadSafetyInformationFirst

DangerousVoltageMayBePresent

Meterisprotectedthroughoutbydoubleinsulationor
reinforcedinsulation. 
When servicing, use only specified replacement parts.
1. SPECIFICATIONS
1-1 General information