Sound Level Meter
14
DataLogger
When you have Sound Level DATA
LOGGER meter connected to PC and select
"DataLogger" from main menu or click
from tool bar to load recorded data from the
meter and there will be a progress indicator
to show the loading progress, if error occurs,
just click "DataLogger" again.
After the data was loaded, the left hand side
will show how many data sets were loaded
and detail information for each data set
(start data, start time, recording rate and
record numbers).
It will transfer first data set to graph and tabular on the right hand side every
time after you load recorded data from the Sound Level Meter and you can
click at any data set to change the set for graph.
On the right hand side sets the waveform graph and statistic information of the
data set you choose as refer to the graph.
for examples:
To Next Page
Loading...
