DATALOGGER HYGRO THERMOMETER
11
7.4 Clearing Data Logger Records:
(1) Turn off the unit.
(2) Press and hold
button and then press power button to turn on the unit.
(3) Keep holding
and button, then LCD will show " ", " CLr " and “ SUrE 5,
4…1, 0 ” until clean the memory. (To abort, release all buttons in process)
7.5 Clearing Instant Read-out Memory:
(1) Turn off the unit.
(2) Press and hold
button and then press power button to turn on the unit.
(3) Keep holding
button, then LCD will show " ", " CLr " and “ SUrE 5, 4…1,
0 ” until clean the memory. (To abort, release
button before “ SUrE 0 ”.)
The LCD will show " CLr " , “ 0 ”and start erasing group 00 to 99 records.
7.6 Connecting To a Computer:
The meter can be connected to PC through a micro USB cable or Bluetooth adapter to download
recorded data or perform real time monitoring or datalogging in the software interface.
8. POWER & BULETOOTH ADAPTER PREPARATION
8.1 Battery Replacement:
(1) When the battery voltage drops below proper operation range, the symbol will blink on
the LCD display and the battery needs to be replaced.
(2) Before replacing the battery, power off the meter, and disconnect all temperature probes.
Open the cover of the battery cabinet by a screwdriver. Replace the old batteries with four new
UM-4 or AAA size batteries.
(3) Close the battery cabinet cover and fasten the screw.
To Next Page
Loading...