Central Machinery 39955 User Manual (English)

Other manuals for Central Machinery 39955

Owner's Manual & Safety Instructions20 pages

Questions and Answers:

J
Jessica EdwardsAug 3, 2025
What to do if my Central Machinery Power Tool will not start?
- D
  Dawn RogersAug 3, 2025
  If your Central Machinery Power Tool won't start, first ensure the cord is properly plugged in. Then, check if the outlet has power. If not, check the circuit breaker, ensuring the circuit's capacity matches the tool's requirements and has no other loads. If the tool has a thermal reset breaker, turn it off, let it cool, and press the reset button. If these steps don't work, internal damage or wear may be the cause, and you should have a technician service the tool.
J
Jennifer RobertsAug 9, 2025
Why is my Central Machinery Power Tool overheating?
- D
  davidbellAug 9, 2025
  Your Central Machinery Power Tool may be overheating because you are forcing the machine to work too fast, so allow the machine to work at its own rate. Another reason may be that the accessory is dull or damaged, so keep cutting accessories sharp and replace them as needed. Also, check for blocked motor housing vents and, while wearing ANSI-approved safety goggles and a NIOSH-approved dust mask/respirator, blow dust out of the motor using compressed air. Finally, the motor might be strained by a long or small diameter extension cord, so eliminate its use. If an extension cord is needed, use one with the proper diameter for its length and load.
S
Sara ScottAug 14, 2025
Why does the performance of my Central Machinery 39955 Power Tool decrease over time?
- H
  hmcconnellAug 15, 2025
  The performance of your Central Machinery Power Tool may decrease over time if the accessory is dull or damaged, so keep cutting accessories sharp and replace them as needed. Another reason may be that carbon brushes are worn or damaged, in which case you should have a qualified technician replace the brushes.
B
butlercarolAug 20, 2025
How to fix excessive noise or rattling in my Central Machinery 39955?
- D
  Debbie JacksonAug 21, 2025
  Excessive noise or rattling in your Central Machinery Power Tool may be due to internal damage or wear, such as with the carbon brushes or bearings, in which case you should have a technician service the tool. Another reason may be that the belt (if equipped) is too loose (slipping) or too tight (causing bearing damage), so properly tension the belt.
R
Roger HowardAug 27, 2025
Why is my Central Machinery 39955 Power Tool operating slowly?
- T
  Troy ClineAug 27, 2025
  Your Central Machinery Power Tool may be operating slowly because the extension cord is too long or the wire size is too small, so eliminate the use of an extension cord. If an extension cord is needed, use one with the proper diameter for its length and load.