To Next PageTo Next Page
Need help?Do you have a question about the Central Machinery 05907 and is the answer not in the manual?
General| Brand | Central Machinery |
|---|---|
| Model | 05907 |
| Category | Power Tool |
| Language | English |
Adjust handle position by removing knob and loosening wing nut.
Adjust segmented upper die fingers for box/pan forming or remove unused ones.
Remove hex screws (#56) from upper cutting blade (#23) to remove it.
Adjust upper blade by placing thin material between upper and lower blades for alignment testing.
Remove hex screws (#59) from lower cutting blade (#23) for removal.
Adjust lower cutting blade using adjustment screws (#61) to set gap between blades.
Scribe mark, position material between blades against guide, then rotate handle to cut.
Mark workpiece, place material above moving cutter plate, align mark with upper die edge, then bend.
Form cylinders and cones using a series of small, closely spaced bends.
Form pans by notching corners, bending sides to 90 degrees, and adjusting for lip height.
Move cover, drop back pressing roll, insert material, tighten bolt, and crank handle.
Use appropriate groove in upper pressing roll for wire gauge and follow rolling procedures.
Slide press plate brackets into receiver holes, center workpiece, and rotate handle to press.
