Page 12 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 93657
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
G(&'+7*#.&&$"83
J(&+7*5 J&##"+7*%O,'#*# T"X*7V%E&7'$"&8#
The motor does
not work.
1. No electrical power.
2. Damaged power cord.
3. Electrical wiring within
the unit is defective.
4. Power switch is defective.
1. Plug power cord into a working,
120VAC, grounded, electrical outlet.
2. Have a qualified service
technician replace power cord.
3. Have a qualified service technician
replace electrical wiring.
4. Have a qualified service technician
replace power switch.
The motor runs,
but it makes
irregular noises or
a knocking noise.
1. Bearing is loose or damaged.
2. Screws in the connection
rod are loose.
1. Have a qualified service
technician replace bearing.
2. Tighten screws, or replace
them if necessary.
Not enough pressure
when painting
or spraying.
1. Loose air connection(s).
2. Air hose is damaged.
3. Screws on cylinder
cover are loose.
1. Check all air connections, and
tighten them if necessary.
2. Replace air hose.
3. Tighten screws.
Motor runs properly,
but no air pressure or
lack of air delivery.
1. Valve plate is loose or out of
place.
2. Retainer ring is damaged
after excessive use
at high pressure.
1. Open the front cover and make
sure the valve plate is in the proper
position. Tighten screws if necessary.
2. Have a qualified service technician
replace the retainer ring.
% ;&77&)%,77%#,2*$V%/(*4,'$"&8#%).*8*W*(%9",38&#"83%&(%#*(W"4"83%
$.*%O&5/(*##&(1%%%
U"#4&88*4$%/&)*(%#'//7V%+*2&(*%#*(W"4*1
To Next Page
Loading...
