Page 10 ;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1 Item 93657
EF;6GH IJ6KFGLIM NFLMG6MFMO6E6GPJ
I/*(,$"83%L8#$('4$"&8#
K*,9%$.*%6MGLK6%LNJIKGFMG%EF;6GH%LM;IKNFGLIM%#*4$"&8%,$%$.*%+*3"88"83%&2%
$."#%5,8',7%"847'9"83%,77%$*Z$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%
$."#%/(&9'4$1
GI%JK6!6MG%E6KLIPE%LMhPKH-%
U&%8&$%,9['#$%&(%$,5/*(%)"$.%,8V%4&8$(&7%&(%4&5/&8*8$%"8%,%),V%8&$%#/*4"2"4,77V%*Z/7,"8*9%
)"$."8%$."#%5,8',71%%L5/(&/*(%,9['#$5*8$%4,8%(*#'7$%"8%$&&7%2,"7'(*%&(%&$.*(%#*("&'#%.,k,(9#1
R*8*(,7%I/*(,$"&8
M&$*- G."#%O&5/(*##&(%)"77%,'$&5,$"4,77V%
#.'$%&22%&8%&W*(7&,9%&(%'89*(%*Z4*##"W*%.*,$1%%
Should this occur, turn Power Switch off. Wait
until the Compressor cools. Then, turn Power
Switch on to resume work.
1. Insert Power Cord plug into grounded outlet.
2. Connect one end of Air Hose to
Air Outlet of Compressor.
3. Connect an Airbrush (not included)
to the other end of Air Hose.
M&$*- Use this Compressor only with
Airbrushes; do not use this Compressor with
any other type of painting equipment.
4. Turn the Power Switch on.
5. Adjust air pressure by lifting the Pressure
Regulator, turning it until proper pressure
is attained, then pressing it back down.
6. When finished using the Compressor,
turn its Power Switch off. Release any
remaining air, then disconnect the Airbrush.
7. Perform maintenance on the
Compressor according to the
instructions on the following pages.
8. Perform maintenance on the
Airbrush according to Airbrush
manufacturer’s instructions.
To Next Page
Loading...
