Central Pneumatic 97855 User Manual (English)

Questions and Answers:

M
Mr. Michael Sanchez DVMJul 30, 2025
Why Central Pneumatic 97855 Paint Sprayer sputters?
- A
  amy33Jul 31, 2025
  Your Central Pneumatic Paint Sprayer might be sputtering due to several reasons: the material level is low (refill it), the cup is tipped too far (hold it upright), the air vent is clogged (clean the vent hole), the fluid inlet connections are loose (tighten them), the fluid needle packing nut is dry or loose (lubricate and/or tighten it), or the fluid tip/seat is loose or damaged (adjust or replace it).
L
laura03Aug 4, 2025
Why Central Pneumatic 97855 Paint Sprayer will not spray?
- K
  Kathleen DanielsAug 4, 2025
  If your Central Pneumatic Paint Sprayer isn't spraying, it could be due to no pressure at the gun (check air hoses), the fluid control not being open enough (open fluid control), or the fluid being too thick (thin the fluid or increase pressure within the maximum range).
R
Robert NealAug 9, 2025
What to do if Central Pneumatic 97855 Paint Sprayer has overspray?
- C
  Christopher HayesAug 9, 2025
  If your Central Pneumatic Paint Sprayer is producing overspray, it could be due to improper application speed (move moderately and parallel), being an improper distance from the workpiece (adjust the distance), or having too much pressure (reduce the air pressure).
F
Frank BushAug 14, 2025
What causes fluid tip leakage in Central Pneumatic 97855 Paint Sprayer?
- S
  Shelly BoothAug 14, 2025
  Fluid tip leakage in your Central Pneumatic Paint Sprayer can be caused by a dirty tip (clean it), a tight packing nut (loosen the packing nut), a broken fluid needle spring (replace it), or a worn or damaged tip (replace the tip and/or needle).
W
Wendy OwensAug 19, 2025
How to fix air leaking from air cap on Central Pneumatic Paint Sprayer?
- M
  michael16Aug 19, 2025
  Air leaking from the air cap of your Central Pneumatic Paint Sprayer can occur due to a dirty air valve/seat (clean it), a sticking air valve (lubricate it), a damaged air valve spring (replace it), a worn or damaged air valve/seat (replace it), or a bent valve stem (replace it).
C
Cheryl CantrellAug 25, 2025
What to do if Central Pneumatic 97855 Paint Sprayer has fluid leaking from packing nut?
- G
  garrettodomAug 25, 2025
  If you notice fluid leaking from the packing nut of your Central Pneumatic Paint Sprayer, it could be because the packing nut is loose (tighten it without restricting) or the packing is worn or dry (replace or lubricate it with a non-silicone lubricant).