Cerber C816 - RF remote control and;or proximity card operating (using Keyfob Module -01); Technical Specifications

6
arming/disarming the user code assigned partitions, tot control PGM1 to PGM4, and for panic alarm (for more details see “Keyfob Module 01 –
Installation and Operating instructions”);
• All the user code rights are assigned to the keyfob functions, too;
• Easy enrollment of the keyfob and/or proximity card, in the time of entering or modifying user code procedure, performed by master user
• User number of the appropriate associated keyfob or card that was used is stored in control panel event log and reported to the Central
Station, having precise information about the user that operated the system by the use of RF remote control or proximity card.
Miscellaneous
• Real clock timer which will stamp the 800 events stored in the control panel event LOG memory;
• “Quick arming” options: “away quick arming”, “quick stay arming” and “quick instant stay arming” – allowed by programming;
• Options of arming by users: “away arming”, “stay arming” and “instant stay arming” – allowed by user rights;
• Autoarming options: “timed autoarming” and “inactivity autoarming” – allowed by programming;
• Option: the system (or each partition independently) automatically switches to stay arming mode after any regular arming (by user, by PC or by
keyswitch), if the user doesn’t leave the protected area through any entry/exit point during the exit delay;
• Option: no beeps/dings during the exit delay of stay arming modes;
• Option: Autoarming programmable in regular or home mode;
• Option: dings (audible sounds on the siren) on keyswitch arming/disarming, arming/disarming - other than keyswitch and during exit delay or for 3
minutes from the moment of initiating the autoarming;
• Option: programmable period and pause for ding sounds;
• Audible warnings for 3 minutes on generation of timed autoarming: 3 minutes from the timed autoarming moment, on the keypad buzzer and
ding sounds optionally.
• Keyswitch arming/disarming or keyswitch “stay arming”/”disarming”, as an option;
• Programmable protection against undesired resets to default values;
• Chime feature activated/deactivated by the users;
• Fuseless design (PCB - hardware system designed with electronic fuse control, to work without fusible resistors);
• Switching power supply
• Current limitation for backup battery charging (200mA).
Technical Specifications:
Power
• 12V/7Ah battery;
• 18Vac/20VA transformer;
• Current consumption in stand-by:
50mA - control panel;