- 80 -
and pushing down the chain midway between the engine sprocket and rear wheel sprocket.
●
If the drive chain is too tight or too loose ,adjust to the standard value.
standard value：20mm-30mm
Chain Slack
Adjustment
●
Loosen the left and right chain adjuster locknuts.
● Remove the cotter pin, and loosen the rear axle locknut.
● If the chain is to loose ,turn the left and right chain adjust nuts clockwise and evenly.
● If the chain is too tight, turn the left and right chain adjust nuts anticlockwise and evenly.
A
To Next Page