15. Engine Removal, Inspection & Installation
z Install thermostat
z Install thermostat cover
z Install water temperature sensor, apply thread
locker to the thread part, tighten it to the
specified torque.
Water temperature sensor
Tightening torque: 10 N·m
z Install intake pipe, apply lubricant to 0-ring.
Camshaft
Check camshaft for wear and run-out of cams and
journals if the engines produces abnormal noise or
vibration or lacks power output. Any of these symptoms
could be caused by wear of camshaft.
Note: Do not try to disassemble the camshaft/automatic
decompression assembly. It is not serviceable.
15-21
To Next Page
Loading...