4. Cooling System
Adding Coolant
Add coolant through filling port. filling port
Start the engine and discharge air from cooling system.
Check from filling port that air is fully discharged from
cooling system and install the radiator cap.
Remove reservoir tank cap and add coolant till the upper
limit.
Note: UPPER LIMIT
Check coolant level when the vehicle is on an even
ground. LOWER LIMIT
Air Discharge
Discharge the air from cooling system according to the
following steps:
1. Remove drain bolt (→4-5), discharge air and install it.
2. Start the engine and run it several minutes at idle
speed;
3. Quickly increase throttle 3~4 times to discharge air
from cooling system;
4. Add coolant till filling port;
5. Repeat step 2 & 3 till no more coolant can be refilled;
6. Check coolant level in reservoir tank and refill till upper
limit.
7. Install reservoir tank cap.
4-6
To Next Page
Loading...